![]() 3016 in diameter, they should be sized without lubricant through a degreased. Now his cast reloads can approach or match the ballistics of factory ammunition with the improved terminal performance of a sofer bullet metal.Ĭasting of these bullets follows standard procedure but there are number of special steps required.Īlthough these bullets are designed with a gas check shank, gas checks do not appear to be neccessary and were not used in our load development. The implications to the hunter are great. 30 caliber alloy bullets which are cast in a somewhat softer alloy. 300 Winchester Magnum indicating these bulllets were accurate up to 3,000 f.p.s.Ĭertainly Colonel Harrison achieved his purpose and bullet casters now have the means to deliver high velocity. ![]() Testing of these bullets occurred, primarily, in match-grade rifles chmbered for the. He performed a great many experiments, recording them in THE AMERICAN RIFLEMAN, and his works resulted in #301618 and #301620 both of which are covered in this Handbook. softer alloy than was normally used for maxium loads, Colonel Harrison turned to paper patching. With the goal of preventing contact between alloy and bore wall and, perhaps, a reduction in metal cost, i.e. The anser to this inquiry came from the past-as they often do. 30 caliber rifle bullets pretty well esablished around 2200-2300 f.p.s., Colonel Harrison, of the NRAT Technical Staff, then turned his attention of a means by with these rifle bullets could be propelled at a greater rate while retaining reasonable accuracy.
0 Comments
Leave a Reply. |